Nosler 470 NE Caliber 500 Grain Solid Bullets (OVER-RUN) - 25ct
470 NE Solid 500 Grain Flat Nose Bullet
The Nosler Solids are exactley that - Solid. Nosler engineers were challenged to design an unrivaled dangerous game bullet that would create the deepest wound channel possible, reliably feed in a bolt action rifle, and share the same point of impact as the Nosler Partition of equal caliber and weight. Needless to say, our engineers had their work cut out for them but in true Nosler fashion, they exceeded expectations. The first step was to mill Nosler Solids from a homogeneous billet of brass alloy in order to maximize strength, consistency, and concentricity. The bullet design starts with a large, flat-nose meplat to minimize deflection off of bone and muscle to punch an impressively long and straight wound channel, even on raking shots. The rebated front section of the bullet was designed to match the chamber pressure of the Nosler Partition of equal caliber and weight in order to achieve same point of impact for both bullets at typical hunting ranges and velocities. the precision cut band allows for tight crimping to ensure each bullet is properly seated and to prevent bullet setback during firing. Whether being used for initial shots on elephant or follow up shots on Cape buffalo, Nosler Solids will give you the bone crushing performance needed when your life is on the line.
This product is a non-blemished product.
Bullet Ballistics Information
Part Number: 28455
Optimal Expansion Velocity: Not Listed
More Information: For additional information view the ADDITIONAL INFO tab above
Product Information Video
Ballistic Gel Test
Not Available at this Time.
Shooters Pro Shop Information
Shooters Pro Shop cannot accept international orders.
Shooters Pro Shop can only ship orders inside the United States.
Bullets, Shooting Bullets, Hunting Bullets, Handloading Bullets, Reloading Bullets, Reloading Supplies, Reloading, Shooting Supplies
|Manufacturer Part Number||28455|
|Ballistic Coefficient (BC)||No|
|Overall Length (OAL) (in.)||No|
|Sectional Density (SD.)||No|
|Factory Type||Factory (Over Run)|